AddPac VoiceFinder AP200 User Manual page 100

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
[Example] DHCP Server Mode Configuration and Usage
router(config)#
router (config)# dhcp-list 0
Gateway should operate as a DHCP server.
router (config)# dhcp-list 1 address server 211.1.1.1
211.1.1.125
DHCP
"211.1.1.125."
Router(config)# dhcp-list 1 option domain-name AddPac
that the Gateway should give AddPac as a domain name to the client
when the Gateway functions as a DHCP server.
Router(config)#
211.1.1.126
Gateway address to the client when the Gateway functions as a DHCP server.
Router(config)# interface Ethernet 0 0
to enter into the configuration mode of the Ethernet 0.0 that is
the interface that the DHCP clients are going to be connected.
Router(config-ether0.0)#
255.255.255.127
"211.1.1.126/25 Bit." At this time, the address shall have the
same network address of DHCP address, and does not exist in the
DHCP pool. IPs may overlap.
Router(config-ether0.0)# dhcp-group 0
packets incoming through Ethernet 0.0 interface should be allocated
with addressed by rules of DHCP-0 that has been set already.
Router(config-ether0.0)# end
mode.
Router# show dhcp-list 0
List 0.
DHCP Type = SERVER
AddPac Technology Co.,Ltd.
☞ In this mode, DHCP-list Config is possible.
☞
Sets the DHCP address pool. This command sets that the
address pool can
☞
Sets that the Gateway should give "211.1.1.126" of default
☞ Sets Ethernet 0.0 interface address as
ADDRESS POOL Start = 211.1.1.1 End = 211.1.1.127
DOMAIN NAME = addpac
Lease Time = 3600, Max lease time = 268435455
type server
allocate addresses
dhcp-list 1
ip
☞ Exists from the configuration
☞ Shows configuration contents of DHCP
☞ Sets that the
from "211.1.1.1"
option gateway-option
☞ Makes the DHCP clients
address 211.1.1.126
☞ Sets that all DHCP
till
☞ Sets
100
- -