AddPac VoiceFinder AP200 User Manual page 245

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
E.164 address with a gatekeeper, use the register e164 command in dial-peer
configuration mode. To deregister an E.164 address, use the no form of this
command.
register e164
no register e164
5.7.4.11.1. Syntax
This command has no keywords or arguments
5.7.4.11.2. Default Value
No default value
5.7.4.11.3. Command Mode
Dial-Peer Configuration Mode
5.7.4.11.4. Usage Guideline
Use this command to register the E.164 address of an analog telephone line
attached to a Foreign Exchange Station (FXS) port on a router. The gateway
automatically registers fully qualified E164 addresses. Use the no register e164
command to deregister an address. Use the register e164 command to register
a deregistered address.
Before you automatically or manually register an E.164 address with a
gatekeeper, you must create a dial peer (using the dial-peer command),
assign an FXS port to the peer (using the port command), and assign an E.164
address (using the destination-pattern command).
The E.164 address must be a fully qualified address. For example, 5551212, and
4085551212 are fully qualified addresses; 408555.... is not a fully qualified
address. E.164 addresses are registered only for active interfaces—those that
are not shut down
AddPac Technology Co.,Ltd.
245
- -