AddPac VoiceFinder AP200 User Manual page 79

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
[[Procedure]
Order
[Related Commands and Syntax]
Standard IP Access-List: The standard IP address-lists uses only the source IP
address in checking the access conditions.
access-list <access-list-number> {deny/permit} <source-address > <source
wildcard>
1. Creates an access-list.
2. access-list-number: Any number within 0 to 29, source: Source Network
3. Instead a pair of "source" and "source-wildcard," the user can use a
4. Wildcard is the inverse mask. For example, if the user writes 132.1.20.1
5. Since the default is the deny value, it is recommended to use "Permit
AddPac Technology Co.,Ltd.
1 Go to the configuration mode.
Create an access-list defining the access-list number and
2
access conditions.
3 Go to the interface configuration mode.
4 Enter into the IP configuration mode.
apply the access-list that has been set to the corresponding
interface.
5
Decide where to apply the access conditions – inbound
packets or outbound packets.
Use "Show access-list" command to check if the access-list has
6
been correctly set.
Address, Source-wildcard: Inverse mask of the source address
pair of "any (any address)" and "host (a certain address.)"
255.255.255.0 network in a wildcard form, the network will be 132.1.20.1
0.0.0.255.
Any Option" at the last line to permit all packets that do not satisfy
conditions when every condition cannot be considered.
Operation
79
- -