Voip Peer Configuration - AddPac VoiceFinder AP200 User Manual

VoiceFinder AP200 VoIP Residential Gateway (RGW) User's Guide Version 1.1
5.3.2.3.

VoIP Peer Configuration

Set the VoIP peer as follows:
Decide the dial peer tag value.
Decide the destination pattern.
Decide the session target.
In most of the cases, other values than these shall be default values.
Step
1 Router# configure
2 Router(config)# dial-peer voice
3 Router(config-dial-peer)#
string
4 Router(config-dial-peer)#
destination-ip-address
5 Router(config-dial-peer)#
[h245-alphanumeric]
AddPac Technology Co.,Ltd.
Command
[T]
Enters into the configuration mode.
Enters into the VoIP configuration
tag
VoIP
mode
configuration.
The tag is the only identifier of the
dial-peer of this system, and tag
values range from 0 to 65535.
The VoIP means communication
service configuration of the VoIP
peer.
Enters the telephone number of the
destination-pattern
corresponding dial peer.
The string means the telephone
number, and string values include 0
~ 9, (#), (*) and wildcard (.).
The period (.) means the wildcard.
Users can selectively enter (T) after
the telephone number, and if a
user enters (T) the system will
collect
end-of-dialing key (default #) or till
the inter-digit timer finishes.
Enters
session target
corresponding VoIP peer.
The destination-ip-address shall be
entered as a dotted decimal IP
address. (Example: 123.321.1.2)
If the destination-ip-address is "ras"
the IP address of the corresponding
VoIP peer will be found through the
gatekeeper.
(Selectively used.)
dtmf-relay
Decides the DTMF tone transmission
method
VoIP-peer.
The
h245-alphanumeric.
Description
of the dial-peer
dial digits till
the IP address of
for the corresponding
default value
153
-
the
the
is
-