Rsvp-Te; Service Manager; Sonet; Src Software And Sdx Software - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - RELEASE NOTES 2010-11-09 Release Note

RSVP-TE

Service Manager

SONET

SRC Software and SDX Software

Stateful SRP Switchover (High Availability) and IP Tunnels

Copyright © 2010, Juniper Networks, Inc.
After stateful SRP switchover, forwarding of VPN traffic might not resume if the core

interface that carries an MPLS base tunnel with LDP over RSVP-TE flaps (constantly
goes up and down). [Defect ID 182019]
After you activate an independent IPv6 service and issue either of the following

commands on the default virtual router or any other virtual router, except the one on
which the subscriber session is active, no output is displayed in the CLI interface:
[Defect ID 181929]
 show service-management subscriber-session subscriberName interface
interfaceType interfaceSpecifier
 show service-management subscriber-session subscriberName interface
interfaceType interfaceSpecifier service-session serviceName
This problem also occurs when a subscriber is authenticated using a RADIUS
server for a combined IPv4 and IPv6 service in a dual stack.
Work-around: To avoid this problem, use the show service-management
owner-session ownerName ownerId command to display subscriber session
information based on the session owner, instead of the show service-management
subscriber-session subscriberName interface interfaceType command to display
details on subscriber sessions.
You cannot use the highest sensitivity bit-error rate setting (a value of 9) associated

with APS/MSP alarm when you issue the threshold sd-ber command to configure a
cOCx/STMx line module with cOC12-APS-capable IOAs. [Defect ID 72861]
Work-around: Use only a value in the range 5–8 when you issue the threshold sd-ber
command for this module combination, as in the following example:
host1(config)#controller sonet 2/1
host1(config-controll)#aps group boston
host1(config-controll)#aps protect
host1(config-controller)#threshold sd-ber 6
When multiple IPv6 interfaces are configured with policies attached from SRC, only

some of the IPv6 interfaces have the policies attached. [Defect ID 179498]
Changing the SSCC status (enable/disable) while IPv6 interfaces are configured

might cause the SRP to reset. [Defect ID 179537]
A packet loss sometimes occurs during stateful SRP switchover when you use the

ping command on a router that is configured for OSPF graceful restart, and is
connected to a helper router in the OSPF IPv6 broadcast network and another helper
router in the OSPF IPv6 backbone area. [Defect ID 181470]
 ERX7xx model, ERX14xx model, or ERX310 router:
Release 11.3.0
Known Problems and Limitations 51