Chapter 27 Configuring Service Manager - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Chapter 27
Configuring Service Manager
Service Manager Overview
This chapter describes how to use the Service Manager application to define, activate,
and monitor networking services for your subscribers. This chapter discusses the
following topics:
Service Manager Overview on page 635
Service Manager Platform Considerations on page 637
Service Manager References on page 637
Service Manager Configuration Tasks on page 637
Service Definitions on page 639
Referencing Policies in Service Definitions on page 644
Referencing QoS Configurations in Service Definitions on page 645
Configuring the Service Manager License on page 653
Managing and Activating Service Sessions on page 654
Using RADIUS to Manage Subscriber Service Sessions on page 654
Using Mutex Groups to Activate and Deactivate Subscriber Services on page 661
Combined and Independent IPv4 and IPv6 Services in a Dual Stack
Overview on page 663
Activation and Deactivation of IPv4 and IPv6 Services in a Dual Stack on page 664
Configuring RADIUS Accounting for Service Manager on page 666
Using the CLI to Manage Subscriber Service Sessions on page 671
Configuring Service Manager Statistics on page 680
Service Manager Performance Considerations on page 684
Service Definition Examples on page 684
The JUNOSe Service Manager application provides authentication, service selection,
and service activation and deactivation to subscribers. The application also collects
accounting information and statistics, and monitors subscriber and service sessions.
Service Manager supports two client types RADIUS and CLI. Service Manager starts
when it receives a request from a RADIUS or CLI client. For RADIUS clients, RADIUS
Access-Accept messages and Change-of-Authorization-Request (CoA-Request)
Service Manager Overview
635