Table of Contents
Advertisement
CHAPTER 27
Configuring Service Manager
Service Manager Overview
Copyright © 2010, Juniper Networks, Inc.
This chapter describes how to use the Service Manager application to define, activate,
and monitor networking services for your subscribers. This chapter discusses the following
topics:
Service Manager Overview on page 623
Service Manager Platform Considerations on page 625
Service Manager References on page 625
Service Manager Configuration Tasks on page 625
Service Definitions on page 627
Referencing Policies in Service Definitions on page 632
Referencing QoS Configurations in Service Definitions on page 632
Configuring the Service Manager License on page 640
Managing and Activating Service Sessions on page 641
Using RADIUS to Manage Subscriber Service Sessions on page 641
Using Mutex Groups to Activate and Deactivate Subscriber Services on page 648
Combined and Independent IPv4 and IPv6 Services in a Dual Stack Overview on page 650
Activation and Deactivation of IPv4 and IPv6 Services in a Dual Stack on page 652
Configuring RADIUS Accounting for Service Manager on page 653
Using the CLI to Manage Subscriber Service Sessions on page 658
Configuring Service Manager Statistics on page 667
Service Manager Performance Considerations on page 671
Service Definition Examples on page 671
The JunosE Service Manager application provides authentication, service selection, and
service activation and deactivation to subscribers. The application also collects accounting
information and statistics, and monitors subscriber and service sessions.
Service Manager supports two client types—RADIUS and CLI. Service Manager starts
when it receives a request from a RADIUS or CLI client. For RADIUS clients, RADIUS
Access-Accept messages and Change-of-Authorization-Request (CoA-Request)
623
Advertisement
Table of Contents
Troubleshooting
