Chapter 27 Configuring Service Manager - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

Chapter 27
Configuring Service Manager
Service Manager Overview
This chapter describes how to use the Service Manager application to define, activate,
and monitor networking services for your subscribers. This chapter discusses the
following topics:
Service Manager Overview on page 641
Service Manager Platform Considerations on page 643
Service Manager References on page 643
Service Manager Configuration Tasks on page 643
Service Definitions on page 645
Referencing Policies in Service Definitions on page 650
Referencing QoS Configurations in Service Definitions on page 651
Configuring the Service Manager License on page 659
Managing and Activating Service Sessions on page 660
Using RADIUS to Manage Subscriber Service Sessions on page 660
Using Mutex Groups to Activate and Deactivate Subscriber Services on page 667
Combined and Independent IPv4 and IPv6 Services in a Dual Stack
Overview on page 669
Activation and Deactivation of IPv4 and IPv6 Services in a Dual Stack on page 670
Configuring RADIUS Accounting for Service Manager on page 672
Using the CLI to Manage Subscriber Service Sessions on page 677
Configuring Service Manager Statistics on page 686
Service Manager Performance Considerations on page 690
Service Definition Examples on page 690
The JUNOSe Service Manager application provides authentication, service selection,
and service activation and deactivation to subscribers. The application also collects
accounting information and statistics, and monitors subscriber and service sessions.
Service Manager supports two client types RADIUS and CLI. Service Manager starts
when it receives a request from a RADIUS or CLI client. For RADIUS clients, RADIUS
Access-Accept messages and Change-of-Authorization-Request (CoA-Request)
Service Manager Overview
641