Table 40: Aaa Accounting Message Juniper Network (Vendor Id 4874) Vsas - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Table 40: AAA Accounting Message Juniper Network (Vendor ID 4874) VSAs Supported
Attribute
Number Attribute Name
[26-10] Ingress-Policy-Name
[26-11] Egress-Policy-Name
[26-24] Pppoe-Description
(See Note 1.)
[26-42] Acct-Input-Gigapackets
[26-43] Acct-Output-Gigapackets
[26-44] Tunnel-Interface-Id
[26-45] Ipv6-Virtual-Router
[26-46] Ipv6-Local-Interface
[26-47] Ipv6-Primary-DNS
[26-48] Ipv6-Secondary-DNS
[26-51] Disconnect-Cause
[26-53] Service-Description
[26-55] DHCP-Options
(See Note 1.)
[26-56] DHCP-MAC-Address
(See Note 1.)
[26-57] DHCP-GI-Address
(See Note 1.)
[26-62] MLPPP-Bundle-Name
value as the Accounting-On message, but also contains the ICR-Partition-Id
VSA, which specifies the ICR partition to which this message corresponds.
Partition-Accounting-Off Sent to the RADIUS server when the partition
changes from the master state to the backup state. However, in the event
of a complete chassis failure, the Partition-Accounting-Off message is not
sent. Partition-Accounting-Off message has the same Acct-Status-Type
attribute value as the Accounting-Off message and contains the
ICR-Partition-Id VSA to denote the ICR partition to which the message is
associated.
For more information about how to configure and use ICR partitions, see the
Managing Interchassis Redundancy chapter in the JUNOSe Services Availability
Configuration Guide.
Acct-Start Acct-Stop
–
–
–
Chapter 3: Configuring RADIUS Attributes
Interim-Acct Acct-On Acct-Off
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
– – –
– –
– –
– –
– –
– –
Subscriber AAA Accounting Messages
Partition- Partition-
Accounting- O n Accounting-Off
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
– –
179