Xerox ColorQube 9303 Series Service Manual page 78

Y N
Refer to WD 5.1. Check Q05-204.
References:
• GP 11 How to Check a Sensor.
• P/J184, DADH PWB.
• 01D +5V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• DADH feed sensor, PL 5.15 Item
• DADH PWB, PL 5.10 Item 5.
Enter dC330 code 05-206 to check the DADH pre-reg sensor, Q05-206,
ate Q05-206. The display changes.
Y N
Refer to WD 5.1. Check Q05-206.
References:
• GP 11 How to Check a Sensor.
• P/J184, DADH PWB.
• 01C +3.3V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• DADH pre-reg sensor, PL 5.25 Item
• DADH PWB, PL 5.10 Item 5.
Completely open the DADH width guides. Refer to
8. Completely close the DADH width guides. The voltage changes from approximately 3.3V
to approximately 0V.
Y N
Remove the DADH input tray assembly,
width sensor is installed correctly, Figure
guides. Install new components as necessary:
• DADH width sensor, PL 5.35 Item
• DADH input tray assembly, PL 5.35 Item
Go to dC131. Check that the IIT DADH NVM parameters for the detection of the size of paper
are correct. Install new components as necessary:
• DADH PWB, PL 5.10 Item 5.
• DADH input tray assembly, PL 5.35 Item
Status Indicator RAPs
05-257-00
2.
PL 5.25 Item
1.
WD 5.2. Measure the voltage at P/J190 pin
PL 5.35 Item 1. Make sure the arm of the DADH
1. Check the mechanical operation of the width
11.
1.
1.
1. Actu-
Arm
February 2013
2-54
DADH width sensor
Q05-095
Figure 1 Component location
ColorQube® 9303 Family