Rep 12.38-171 Hvf Stacker Driving Belts - Xerox ColorQube 9303 Series Service Manual

REP 12.38-171 HVF Stacker Driving Belts

Parts List on PL 12.105.
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
NOTE: The removal and replacement procedure for the front and rear stacker driving belts is
the same. Support the Bin 1 lift bar if removing the front and rear belts at the same time
1. Remove the front or rear cover to access the front or rear driving belt
2. Remove the stacker bin 1 tray REP
ColorQube® 9303 Family
WARNING
WARNING
GP 14. Disconnect the power cord
REP 12.1-171.
12.4-171.
3. Remove the stacker driving belt,
Replacement
NOTE: Check that the bin 1 lift bar is level before fitting the belt clamp.
Reverse the removal procedures to reinstall the front and rear stacker driving belts.
February 2013
4-175
Figure 1.
3
Remove the circlip
and upper pulley if
required.
4
Remove the
belt.
1
Remove the screw
and belt clamp.
2
Remove the circlip and
lower pulley.
Figure 1 Stacker Driving Belts
Repairs/Adjustments
REP 12.38-171