Table of Contents
Advertisement
03-346-00 Unable To Communicate With UI RAP
03-346-00 Unable to re-establish communication with the UI after 30 seconds.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
GP
14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
1.
Switch off the machine, then switch on the machine,
2.
Reload the software set,
GP 4
Machine Software.
ColorQube® 9303 Family
WARNING
GP
14.
03-347-00 Main Controller PWB Cannot Communicate with
UI PWB RAP
03-347-00 The single board controller PWB to UI control PWB communications have failed.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
•
Switch off the machine, then switch on the machine,
•
Check the fault history file for other 03-xxx fault codes. If the 03-xxx fault codes occur ran-
domly, the cause may be due to electrical noise. Go to
Procedure
1.
Switch off the machine,
PL 3.11 Item 13
and the UI control PWB,
seated. Switch on the machine,
2.
Re-load the software set,
3.
Refer to
WD
3.2. Check the wiring between PJ19 on the
PJ900, PJ901 and PJ905 on the
sary,
REP
1.1. If necessary, install a new user interface harness,
4.
Install new components as necessary:
•
User interface control PWB,
•
Single board controller PWB,
February 2013
2-45
WARNING
GP
14. Disconnect the power cord. Electricity can cause
GP
14.
OF 10
Intermittent Failure RAP.
GP
14. Ensure all the connectors on the single board controller,
PL 2.10 Item 2
are correctly and securely
GP
14.
GP 4
Machine Software.
single board controller PWB
User Interface control
PWB. Repair the wiring as neces-
PL 2.10 Item
2.
PL 3.11 Item
13.
03-346-00, 03-347-00
and
PL 2.10 Item
7.
Status Indicator RAPs
Advertisement
Chapters
Table of Contents
