Xerox ColorQube 9303 Series Service Manual page 181

Figure 2 Component location
ColorQube® 9303 Family
12-479-00-171 Inserter Paper Length Fault RAP
12-479-00-171 A shorter than expected sheet has been fed from the inserter.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Check that the inserter paper path is clear of obstructions and the sensors are clean.
Procedure
Figure 1
Enter the
The display changes.
Y
Pressing and support
A sensor
Enter the
The display changes.
Y
Enter the
The display changes.
Y
A
February 2013
2-157
WARNING
GP 14. Disconnect the power cord. Electricity can cause
shows the component locations.
dC330 code 12-079, inserter paper length sensor 1, Q12-079. Actuate the sensor.
N
Go to WD 12.13, WD 12.21 and WD 12.22. Check the inserter paper length sensor 1,
Q12-079. Refer to:
• GP 11 How to Check a Sensor.
• 12A-171, HVF Power Distribution RAP.
• 01L 0V Distribution RAP
Install new components as necessary:
• Inserter paper length sensor 1, PL 12.300 Item
• Inserter PWB, PL 12.310 Item 9.
• HVF PWB, PL 12.140 Item 2.
dC330 code 12-080, inserter paper length sensor 2, Q12-080. Actuate the sensor.
N
Go to WD 12.13, WD 12.21 and WD 12.22. Check the inserter paper length sensor 2,
Q12-080. Refer to:
• GP 11 How to Check a Sensor.
• 12A-171, HVF Power Distribution RAP.
• 01L 0V Distribution RAP
Install new components as necessary:
• Inserter paper length sensor 2, PL 12.300 Item
• Inserter PWB, PL 12.310 Item 9.
• HVF PWB, PL 12.140 Item 2.
dC330 code 12-090, inserter paper length sensor 3, Q12-090. Actuate the sensor.
N
Go to WD 12.14 and WD 12.22. Check the inserter paper length sensor 3, Q12-090.
Refer to:
• GP 11 How to Check a Sensor.
• 12A-171, HVF Power Distribution RAP.
• 01L 0V Distribution RAP
12-473-00-171 to 12-478-00-171, 12-479-00-171
12.
12.
Status Indicator RAPs