Xerox ColorQube 9303 Series Service Manual page 102

10-571-00, 10-572-00 Stripper Latch Sensor Error RAP
10-571-00 Stripper latch sensor time out.
10-572-00 Stripper latch bad sensor state.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
WARNING
Take care during this procedure. The stripper blade is very sharp and can cause injury.
WARNING
Do not clean the stripper blade. The stripper blade is very sharp and can cause injury. If
the stripper blade is dirty a new blade must be installed.
• Unlatch, then fully latch the stripper blade,
Procedure
Enter the dC330 code 10-014 to monitor the stripper latch sensor,
dC330 code 10-023 to run the post transfix motor (M4), PL MOT10-018,
reverse to latch the stripper gate. MOT10-018 runs.
Y N
Refer to WD 8.2. Check MOT10-018. Refer to:
• GP 10, How to Check a Motor.
• P/J303, Media Path Driver PWB.
• 01J +50V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Post transfix motor (M4), PL 10.10 Item
• Media path driver PWB, PL 1.15 Item
Stack the code 10-025 to run the post transfix motor (M4) to unlatch the stripper gate. The
sensor display changes.
Y N
Remove the post transfix motor (M4) and the gear drive, refer to
damage. The gear drive is good.
Y N
Install new components as necessary,
Refer to WD 9.3. Check the stripper latch sensor, Q10-014. Refer to:
• GP 11, How to Check a Sensor
• P/J801 Drum driver PWB.
• 01B +3.3V ESTAR Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Stripper latch sensor, PL 10.10 Item
A
Status Indicator RAPs
10-571-00, 10-572-00
GP 31.
PL 10.10 Item 17. Stack
PL 10.10 Item 5
5.
5.
REP 10.8. Check for
PL 10.10.
17.
A
• Drum driver PWB, PL 1.15 Item
Check all components in the stripper system for damage,
• Front latchfork, PL 10.10 Item 11
• Back latchfork, PL 10.10 Item
• Return spring, PL 10.10 Item
• Stripper latch cam, PL 10.10 Item
Install new components as necessary,
in
February 2013
2-78
4.
PL 10.10. Pay special attention to:
12.
14.
15.
PL 10.10.
ColorQube® 9303 Family