Xerox ColorQube 9303 Series Service Manual page 989

3. Remove the top cover door and the interlock switch,
3
Remove 2 screws from
the rear.
5
Release the cable harness
clips and lift the top inside
cover.
Figure 1 Jam cover Interlock Switch
Replacement
1. Reverse the removal procedures to replace the jam cover interlock switch.
2. When reinstalling the top inside cover and the top cover door make sure that the correct
screws are used and that the screws are not overtightened.
ColorQube® 9303 Family
Figure 1.
1
2
Remove the
Remove 2 latch
rear pivot screw,
pins.
then the top
cover.
4
Remove 2 screws
from the front.
6
Remove the jam cover
interlock switch.
REP 12.89-171 Main Tray and Paper Length Sensors
Parts List on PL 12.300.
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Pull the lug on one side of the tray to disconnect from the frame pivot. Remove the cover
plate then disconnect the PJs and remove the sensors from the bracket clips,
1
Pull the lug on one side of the
tray to disconnect from the
frame pivot.
Replacement
Reverse the removal procedures to replace the Inserter main tray and paper length sensors.
February 2013
4-231
WARNING
WARNING
GP 14. Disconnect the power cord
Figure 1 Main Tray Assembly
REP 12.88-171, REP 12.89-171
Figure 1
3
Remove the rele-
vant paper length-
sensor.
2
Remove 2 screws,
then the cover plate.
Repairs/Adjustments