Xerox ColorQube 9303 Series Service Manual page 197

12L-171 Tri-Folder Not Detected RAP
Use this RAP when the machine fails to detect the tri-folder module.
NOTE: The machine must be loaded with A4 or 8.5 x 11 inch SEF paper for the tri-folder to
function. Also, booklet mode will only be available if A4, 11, 14 or 17 inch paper is loaded in the
machine.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Check for damage or obstructions that would prevent the tri-folder from operating correctly.
Procedure
Go to WD 12.19. Check the wiring of the tri-folder present link, and repair as necessary,
1.1. Check for 0V at PJ563, pin 7. Refer to:
• 12A-171 HVF Power Distribution RAP.
• 01L 0V Distribution RAP.
ColorQube® 9303 Family
WARNING
12M-171 Buffer Path Clamp Problems RAP
Use this RAP when having problems with the buffer path clamp on the HVF. Problems in this
area result in paper jams at the exit and poor compiling.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Check that the solenoid and the clamp can move freely without obstruction.
Procedure
Figure 1 shows the location of the components.
Enter the dC330 code 12-056, set clamp solenoid. The solenoid actuates.
Y N
REP
Go to WD 12.8 and check the wiring. Repair as necessary,
Refer to:
• GP 12 How to Check a Solenoid or Clutch.
• 12A-171 HVF Power Distribution RAP.
• 01L 0V Distribution RAP
Install new components as necessary:
• Set clamp solenoid,
• HVF PWB, PL 12.140 Item
Perform SCP 5 Final Actions.
February 2013
2-173
WARNING
GP 14. Disconnect the power cord. Electricity can cause
REP
PL 12.120 Item 4.
2.
12L-171, 12M-171
1.1. Check SOL12-056.
Status Indicator RAPs