Rep 10.24 Front And Rear Flexure Encoder - Xerox ColorQube 9303 Series Service Manual

REP 10.24 Front and Rear Flexure Encoder

Parts List on PL 10.20
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. The stripper blade is very sharp and can cause injury.
1. Open the front door.
2. Remove the inner cover, PL 81.11 Item
3. Remove the front cover and front flexure encoder,
3
Remove the sensor 2
Disconnect the harness
Figure 1 Front flexure encoder
4. Remove the rear cover, PL 81.10 Item
5. Remove the post transfix motor (M4) and gearbox,
Repairs/Adjustments
REP 10.24
WARNING
GP 14. Disconnect the power cord
WARNING
2.
Figure 1.
1
Remove 2 screws
1.
Figure 2.
3
Remove the
motor and
gearbox
2
Disconnect motor harness
Figure 2 Post transfix motor and gearbox
6. Remove the rear flexure encoder,
3
Remove the encoder
2
Remove 2 screws
Replacement
Take care not to damage or contaminate the flexure encoder.
1. Replacement is the reverse of the removal procedure.
February 2013
4-98
1
Remove 3 screws
Figure 3.
1
Disconnect the harness
Figure 3 Rear flexure encoder
CAUTION
ColorQube® 9303 Family