Xerox ColorQube 9303 Series Service Manual page 72

03-401-00, 03-403-00 Fax Not Detected RAP
03-401-00 The basic fax module has not been detected or confirmed.
03-403-00 Extended fax PWB has not been confirmed or detected. This is for information only.
The machine does not have an extended fax PWB.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
1. Switch off the machine, then switch on the machine,
2. Check that the Fax module, PL 20.05 Item
3. Perform the Initial Actions in 20A Fax Entry RAP.
4. Perform the 20G Fax Module Checkout RAP.
5. If necessary, install a new Fax module,
6. If necessary, re-load the software set,
7. Install new components as necessary:
• Single board controller PWB,
Status Indicator RAPs
03-401-00, 03-403-00, 03-417-00
WARNING
GP 14.
1, has been installed.
PL 20.05 Item 1.
GP 4 Machine Software.
PL 3.11 Item 13.
03-417-00 Incompatible Fax Software RAP
03-417 The fax software version supplied at power up is not compatible with the image pro-
cessing software.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Switch off the machine, then switch on the machine,
Perform the following:
• Reload the software set,
• If necessary, install a new Fax module,
February 2013
2-48
WARNING
GP 14. Disconnect the power cord. Electricity can cause
GP 14.
GP 4, Machine Software.
PL 20.05 Item 1.
ColorQube® 9303 Family