Rep 12.3-110 Intermediate Paper Drive Belt - Xerox ColorQube 9303 Series Service Manual

REP 12.3-110 Intermediate Paper Drive Belt

Parts List on PL 12.60.
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the LCSS rear cover REP
2. Remove the intermediate paper drive belt,
2
3
Disconnect PJ307.
Disconnect the bulkhead connector.
Figure 1 Removing the drive belt
ColorQube® 9303 Family
WARNING
GP 14. Disconnect the power cord
WARNING
12.1-110.
Figure 1.
1
Disconnect the spring.
4
Remove the drive belt.
Replacement
1. Lubricate the belt tensioner, refer to
2. Install the belt over the pulleys, ensuring that the belt is on all five pulleys.
NOTE: Two of the pulleys are free to slide along the shaft. Ensure the belt is correctly
located on these pulleys.
3. Install the LCSS rear cover,
February 2013
4-101
ADJ 4.1.
REP 12.1-110.
Repairs/Adjustments
REP 12.3-110