Rep 5.2 Top Access Cover Assembly - Xerox ColorQube 9303 Series Service Manual

REP 5.2 Top Access Cover Assembly

Parts List on PL 5.20
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Open the DADH top cover.
2. Remove the DADH rear cover, PL 5.10 Item
3. Remove the DADH top cover assembly,
4. Remove the DADH top access cover assembly,
3
Remove the top access
cover assembly.
Figure 1 Top access cover assembly
Repairs/Adjustments
REP 5.2
WARNING
GP 14. Disconnect the power cord
1.
REP 5.1.
Figure 1.
2
Remove the screw and
the bracket.
1
Disconnect PJ191 and
the ground harness.
Replacement
The replacement is the reverse of the removal procedure. Make sure that the 2 springs on the
idler rolls are in the correct position,
CVT idler roll torsion
spring
February 2013
4-38
Figure 2. Then install the top cover.
Takeaway idler roll
torsion spring
Figure 2 Torsion springs
ColorQube® 9303 Family