Xerox ColorQube 9303 Series Service Manual page 484

94-527-00, 94-531-00 Cleaning Unit Early Life Over Current
RAP
94-527-00 Oil delivery pump (early life) is taking too much current.
94-531-00 Oil delivery pump (early life) is taking too much current.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
These faults are shown for information only. No corrective actions are necessary. If the fault
becomes more serious, faults 94-528-00, 94-532-00 or 94-533-00 will be raised.
Status Indicator RAPs
94-527-00, 94-531-00, 94-528-00, 94-532-00, 94-533-00
WARNING
94-528-00, 94-532-00, 94-533-00 Cleaning Unit Over
Current RAP
94-528-00 Drum driver oil pump 1 is taking too much current.
94-532-00 Drum driver oil pump 2 is taking too much current.
94-533-00 Drum driver oil valve is taking too much current.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Use care when working near the drum. The drum can be damaged easily, which will cause
print quality defects.
Install a new cleaning unit, PL 94.10 Item
present with the new cleaning unit.
Y N
Perform SCP 5 Final Actions.
Remove the new cleaning unit, refer to
to REP 91.24. Check the 12 pin connector,
between the cleaning unit and the drum driver PWB. Repair the wiring as necessary,
or install a new harness, PL 1.15 Item
Install new components as necessary:
• 12 pin connector, PL 94.10 Item
• Drum driver PWB, PL 1.15 Item
February 2013
2-460
WARNING
GP 14. Disconnect the power cord. Electricity can cause
CAUTION
21. Make 20 copies. Wait 1 minute. The fault is still
REP 94.1. Remove the drum drive motor and belt, refer
PL 94.10 Item 6. Go to WD
17. Reinstall the original cleaning unit.
6.
4.
ColorQube® 9303 Family
9.2. Check the wiring
REP 1.1