Table of Contents
Advertisement
13.
Figure
5, remove the BM stapler bracket assembly.
Figure 5 Assembly removal
Replacement
Reverse the removal procedure to replace the BM stapler bracket assembly and components.
ColorQube® 9303 Family
REP 12.29-171 BM Conveyor Belts
Parts List on
Removal
1
Lever out
the bearing
Take care during this procedure. Sharp edges may be present that can cause injury.
using a
screwdriver.
Switch off the electricity to the machine
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
NOTE: The removal procedure illustrates how to remove the rear conveyor belt. The proce-
dure for the front conveyor belt is similar.
1.
Remove bin 2 by disconnecting the harness, removing the thumb screw then lifting the bin
upwards to release.
2.
Remove the BM bin 2 extension by aligning the pivot pins with the cutouts and snapping
the extension out of engagement.
3.
Turn over bin 2 and remove the base pan, 3 screws.
2
4.
Remove the BM bin 2 connector from the base pan, 1 screw.
Remove the
bracket
assembly
from the front.
February 2013
4-163
PL
12.190.
WARNING
WARNING
GP
14. Disconnect the power cord from the cus-
REP 12.28-171, REP 12.29-171
Repairs/Adjustments
Advertisement
Chapters
Table of Contents
