Xerox ColorQube 9303 Series Service Manual page 905

3. Remove the crease roll motor assembly,
NOTE: As necessary, cut any tie wraps securing the crease roll motor harness.
1
Remove 3
screws.
Figure 1 Motor assembly removal
ColorQube® 9303 Family
Figure 1.
3
Pull the motor
assembly off.
2
Disconnect
the motor
harness.
Replacement
1. Reverse the removal procedure to replace the BM crease roll motor.
2. Before installing the motor check that the bearing is located on the drive shaft,
Figure 2 Location of bearing on drive shaft
February 2013
4-147
Figure 2.
Check that the bearing is
on the drive shaft.
Repairs/Adjustments
REP 12.19-171