Rep 5.20 Mylar Guide Strip - Xerox ColorQube 9303 Series Service Manual

3. Remove the DADH from the machine,
2
Remove
the DADH.
Figure 1 DADH removal
Replacement
1. The replacement is the reverse of the removal procedure.
2. If a new DADH is installed, perform the steps that follow:
a. Attach the document pad, refer to
b. Reset the DADH feed count to zero. Refer to
c. DADH height adjustment, ADJ
d. DADH registration adjustment,
e. DADH skew adjustment, ADJ
Repairs/Adjustments
REP 5.19, REP 5.20
Figure 1.
1
Remove 2 thumbscrews.
ADJ 5.6.
dC135 CRU / HFSI Status.
5.2.
ADJ 5.5.
5.3.

REP 5.20 Mylar Guide Strip

Parts List on PL 5.30
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Raise the DADH.
2. Open the baffle assembly,
3. Remove the old mylar guide strip,
4. Use cleaning fluid to remove any contamination from the baffle assembly.
Replacement
1. Remove the 3 backing strips from the pressure sensitive adhesive tape on the mylar
guide.
2. Adhere the mylar guide to the baffle assembly,
February 2013
4-58
WARNING
GP 14. Disconnect the power cord
PL 5.30 Item 14.
PL 5.30 Item 12.
Figure 1.
1
Bias the corner of the
mylar guide with the edge
of the baffle assembly.
2
Position the centre of the
mylar guide over the
centre rib.
Figure 1 Mylar guide
ColorQube® 9303 Family