Xerox ColorQube 9303 Series Service Manual page 166

12-392-00-171 to 12-395-00-171 HVF Front Tamper Fault
RAP
12-392-00-171 The front tamper did not move from the home position.
12-393-00-171 The front tamper did not return to the home position.
12-394-00-171 The front tamper did not enter the away position.
12-395-00-171 The front tamper did not move from the away position.
Initial Actions
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Check for damage or obstructions that would prevent the front tamper from operating cor-
rectly.
• Jams can be caused if the tray settings do not match the paper in the trays. Make sure the
tray settings are correct.
Procedure
Figure 1 shows the location of the components.
Enter dC330, code 12-228 to move the tamper inboard, then enter 12-226 to move the tamper
outboard. The tamper moves.
Y N
Go to WD 12.15. Check the wiring and repair as necessary,
tamper motor home, MOT12-226. Refer to:
• GP 10 How to Check a Motor.
• 12A-171 HVF Power Distribution RAP.
• 01L 0V Distribution RAP
Install new components as necessary:
• Front tamper motor, PL 12.125 Item
• HVF PWB, PL 12.140 Item 2.
Stack the dC330 code 12-180, front tamper home sensor, Q12-180. Move the tamper using the
control codes 12-226 and 12-228. The display changes.
Y N
Go to WD 12.15. Check the wiring and repair as necessary,
Refer to:
• GP 11 How to Check a Sensor.
• 12A-171 HVF Power Distribution RAP.
• 01L 0V Distribution RAP
Install new components as necessary:
• Tamper front home sensor, PL 12.135 Item
• HVF PWB, PL 12.140 Item 2.
A
Status Indicator RAPs
12-392-00-171 to 12-395-00-171
REP 1.1. Check the front
6.
REP 1.1. Check Q12-180.
1.
A
Stack the dC330 code 12-182, tamper front away sensor, Q12-182. Move the tamper using the
control codes 12-226 and 12-228. The display changes.
Y N
Go to WD 12.15. Check the wiring and repair as necessary,
Refer to:
• GP 11 How to Check a Sensor.
• 12A-171 HVF Power Distribution RAP.
• 01L 0V Distribution RAP
Install new components as necessary:
• Tamper front away sensor,
• HVF PWB, PL 12.140 Item
Perform SCP 5 Final Actions.
Tamper front away
sensor, Q12-182
February 2013
2-142
REP
PL 12.135 Item 1.
2.
Front tamper
Tamper front home
motor, MOT12-226
sensor, Q12-180
Figure 1 Component location
ColorQube® 9303 Family
1.1. Check Q12-182.