Xerox ColorQube 9303 Series Service Manual page 349

75-320-00 Tray 5 Opened In Run RAP
75-320-00 Tray 5 was opened during run when the paper is fed from tray 5.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Ensure that the door is pushed fully home.
• Check the switch actuator on the door.
Procedure
Enter dC330 code 75-010 tray 5 door switch, S75-010,
fully close the door The display changes.
Y N
Refer to WD 7.2. Check tray 5 door switch, S75-010. Refer to:
• GP 13 How to Check a Switch.
• PJ507, tray 5 control PWB.
• 01D +5V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Tray 5 door switch, PL 75.60 Item
• Tray 5 control PWB, PL 75.68 Item
Check that the door opens and closes and latches correctly. If necessary install new front door
assembly, PL 75.60 Item 1.
ColorQube® 9303 Family
WARNING
PL 75.60 Item 6. Press Start. Open and
6.
8.
75-325-00 Tray 5 Undocked In Run RAP
75-325-00 Tray 5 was undocked during run when the paper is fed from tray 5.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
• Ensure the tray base is located correctly.
• Check for obstructions between the tray 5 module and the machine.
Procedure
Enter dC330 code 75-017 tray 5 docking switch, S75-017,
Undock and dock tray 5, refer to
Y N
Refer to WD 7.2. Check tray 5 docking switch, S75-017. Refer to:
• GP 13 How to Check a Switch.
• PJ507, tray 5 control PWB.
• 01D +5V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Tray 5 docking switch,
• Tray 5 control PWB,
Perform the following:
• Check the docking latch,
• Check the slide assembly,
February 2013
2-325
WARNING
GP 14. Disconnect the power cord. Electricity can cause
PL 75.64 Item
REP 75.7. The display changes.
PL 75.64 Item 1.
PL 75.68 Item 8.
PL 75.62 Item 6 on tray 5 is latched onto the machine.
PL 75.62 Item 12.
75-320-00, 75-325-00
1. Press Start.
Status Indicator RAPs