Xerox ColorQube 9303 Series Service Manual page 471

93-825-00, 93-892-00 Ink Key Plate Motor Over Current
RAP
93-825-00 The ink key plate motor is over current.
93-892-00 Indicates an over current interrupt from the motor driver chip.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
• Clean the ink loading area to ensure that the ink key plate moves smoothly.
Procedure
The ink key motor can overheat if run repeatedly. Allow 2 minutes between each run of the ink
key motor.
Enter dC330 code 93-051 or 052 or 053, to run the ink key plate motor, MOT93-051,
Item 14. MOT93-051 runs.
Y N
Go to WD 8.4. Check MOT93-051.
Refer to:
• GP 10 How to Check a Motor.
• P/J406, Media path driver PWB.
• 01H +24V Distribution RAP.
• 01L 0V Distribution RAP
Install new components as necessary:
• Ink key plate motor, PL 93.10 Item
• Ink loader upper assembly, PL 93.10 Item
• Media path driver PWB, PL 1.15 Item
The key plate moves when the motor runs.
Y N
Clean the ink loading area to ensure that the ink key plate moves smoothly. If necessary,
install a new ink loader upper assembly,
The fault may be intermittent, check the wiring to the ink key plate motor. If necessary, install a
new ink loader upper assembly, PL 93.10 Item
ColorQube® 9303 Family
WARNING
CAUTION
14.
1.
5.
PL 93.10 Item 1.
1.
93-871-00 to 93-874-00 Ink Level Sense Error RAP
93-871-00 Black melt reservoir level sense failure.
93-872-00 Magenta melt reservoir level sense failure
93-873-00 Cyan melt reservoir level sense failure
93-874-00 Yellow melt reservoir level sense failure
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Go to WD 9.9 and WD 9.16. Check the wiring between the ink level sensors, the solenoid
patch PWB and the marking unit driver PWB.
Refer to:
• P/J101, Marking Unit Driver PWB
PL 93.10
• P/J380, P/J760, P/J780
• 01B +3.3V ESTAR Distribution RAP.
• 01L 0V Distribution RAP
Install new components as necessary.
• Ink reservoir, PL 93.10 Item
• Marking unit driver PWB,
NOTE: Ink level sense errors can be caused by ink cross contamination. If the machine was
recently moved, cross contamination may have occurred. If the cross contamination is severe,
it may be necessary to install a new ink reservoir,
February 2013
93-825-00, 93-892-00, 93-871-00 to 93-874-00
2-447
WARNING
GP 14. Disconnect the power cord. Electricity can cause
Solenoid Patch PWB.
10.
PL 92.10 Item 4.
PL 93.10 Item 10.
Status Indicator RAPs