Xerox ColorQube 9303 Series Service Manual page 101

10-570-00 Stripper Solenoid Over Current RAP
10-570-00 Stripper solenoid over current.
Initial Actions
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Take care during this procedure. The stripper blade is very sharp and can cause injury.
Do not clean the stripper blade. The stripper blade is very sharp and can cause injury. If
the stripper blade is dirty a new blade must be installed.
• Check the harness leading to the stripper solenoid,
Procedure
Refer to Figure 1. Lower the stripper gate and baffle assembly,
blade shaft is installed correctly. Slide the shaft forwards and backwards and feel for the shaft
to engage on the detent. Raise the stripper blade into the operating position. Check that the
stripper blade shaft lock is engaging correctly at the front and rear. The stripper blade latch
mechanism is good.
Y N
Install new stripper components as necessary,
Enter dC330 code 10-021 to energize the stripper solenoid, SOL10-021,
The solenoid energizes.
Y N
Refer to WD 9.2. Check the stripper solenoid. Refer to:
• GP 12, How to Check a Solenoid.
• P/J601, Drum driver PWB.
• 01J +50V Distribution RAP.
• 01L 0V Distribution RAP.
Install new components as necessary:
• Stripper solenoid assembly, PL 10.10 Item
• Drum driver PWB, PL 1.15 Item
Check for obstructions that could prevent the stripper solenoid from engaging the stripper
blade. Install new components as necessary,
ColorQube® 9303 Family
WARNING
WARNING
WARNING
PL 10.10 Item 3.
GP 31. Check that the stripper
PL 10.10, PL 10.12.
PL 10.10 Item
3.
4.
PL 10.10, PL 10.12.
Closed
Open
Stripper blade shaft
3.
February 2013
2-77
Stripper blade lock
(Front and rear)
Figure 1 Component location
Status Indicator RAPs
Detent in shaft
10-570-00