Table of Contents
Advertisement
Tri-folder unit
In-line fuse,
(F1)
BM PWB
Figure 3 Component location
Status Indicator RAPs
12A-171, 12B-171
HVF power
supply module
HVF PWB
February 2013
2-162
12B-171 HVF BM to Machine Communications Interface
and BM Present RAP
A communication fault exists between the HVF BM and the machine.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
GP
14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
WD 12.9
and
WD 12.19
show the communications between the booklet maker and the HVF
PWB. For communications between the HVF PWB and the machine go to
The pulses on the connections between PJ133 and PJ562 cannot be measured, but may be
detected using a meter that can record maximum and minimum voltage levels, or by using an
AC voltage range. Check the wiring and repair as necessary,
If necessary, install new components:
•
Booklet maker PWB,
PL 12.175 Item
•
HVF PWB,
PL 12.140 Item
2.
If the machine indicates that the booklet maker is not present, check that PJ133, pin 6 is held
at 0V. If necessary, repair the wiring,
REP 1.1
WARNING
WD
12.9.
REP
1.1.
10.
or install a new HVF PWB,
PL 12.140 Item
ColorQube® 9303 Family
2.
Advertisement
Chapters
Table of Contents
