Xerox ColorQube 9303 Series Service Manual page 128

A
NOTE: If the SH1 priming sensor does not see staples in the primed position, the staple head
cycles a number of times to prime the staple head. This occurs when the LCSS interlocks are
made.
Follow the customer instruction label inside the LCSS front door to remove the staple cartridge,
slide out the top sheet of staples from the cartridge, to expose a fresh sheet of staples on the
top of the stack. Ensure the forming plate is fully closed,
and close the door. The stapler will now cycle a few times to feed and prime the new sheet of
staples. Open the door and remove the staple cartridge. Examine the sheet of staples that
have been fed to the staple forming part of the stapler, by opening the forming plate,
The first two staples have been partially formed.
Y N
Install a new staple cartridge, PL 26.10 Item 16
ples are not partially formed install a new staple head unit,
5 Final Actions
Install a new staple head unit, PL 12.55 Item
Staple head unit
Figure 1 Component location
Status Indicator RAPs
12L-110
Figure 2. Install the staple cartridge
Figure
and repeat the check. If the first two sta-
PL 12.55 Item 5. Perform
5. Perform SCP 5 Final Actions.
SH1 paper sensor
Q12-196
3.
SCP
Figure 2 Staple cartridge closed
February 2013
2-104
Primed staples
Forming plate
closed
ColorQube® 9303 Family