Xerox ColorQube 9303 Series Service Manual page 478

Y N
Install a new 12 pin connector, PL 94.10 Item
Go to WD 9.2, WD 9.4 and WD 9.19. Check the wiring between the cleaning unit and the drum
driver PWB. Repair the wiring as necessary,
17. Reinstall the cleaning unit. Cheat the front door interlock. Listen at the front of the cleaning
unit. The cleaning unit can be heard running.
Y N
Perform SCP 5 Final Actions.
Remove the cleaning unit. Install a new drum drive motor PWB,
front door interlock. Listen at the front of the cleaning unit. The cleaning unit can be heard
running.
Y N
Perform SCP 5 Final Actions.
Check for grounding faults, GP 7 System Grounding Verification.
Status Indicator RAPs
94-505-00, 94-510-00, 94-512-00
6.
REP 1.1 or install a new harness, PL 1.15 Item
PL 1.15 Item 4. unit. Cheat the
94-510-00, 94-512-00 Drum Image Initial Position Error RAP
94-510-00 The imaging software detected the drum at the wrong position.
94-512-00 The drum has stalled during imaging.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
1. Perform the 94-534-00 Drum Drive Belt Slip RAP.
2. If the fault remains, reload the software,
February 2013
2-454
WARNING
GP 14. Disconnect the power cord. Electricity can cause
GP 4 Machine Software.
ColorQube® 9303 Family