Configure Gps Support For The Gobi3000 Module - Digi TransPort WR31 User Manual

Configure telemetry settings
IP Connection 1
GPS data can be sent to up to two IP destinations. These are specified in the following two
sections of the web page.
Send GPS messages to IP address a.b.c.d
The IP address to which the GPS data should be sent.
Port n
The required TCP/UDP port number that the GPS data should be sent to is specified here.
Every n interval(s)
Controls how often the GPS data is transmitted to the specified host.
A value of 1 cause collected GPS data to be transmitted each time a UTC and local date/time
•
data (ZDA) message is received from the GPS receiver module.
A value of 2 causes every second message to be sent and so on.
•
For this feature to work over a TCP/IP connection, the ZDA message must be enabled.
Use TCP / UDP
The protocol to use for sending the messages.
Prefix the message with t
A text string that should precede the NMEA data, if desired.
Suffix the message with t
A text string that should follow the NMEA data, if desired.
IP Connection 2
Send GPS messages to IP address a.b.c.d
The IP address to which the GPS data should be sent.
Port n
The required TCP/UDP port number to which the GPS data should be sent.
Every n interval(s)
How often the GPS data is transmitted to the specified host.
A value of 1 causes collected GPS data to be transmitted each time a UTC and local date/time
•
data (ZDA) message is received from the GPS receiver module.
A value of 2 causes every second message to be sent and so on.
•
For this feature to work over a TCP/IP connection, the ZDA message must be enabled.
Digi TransPort WR Routers User Guide
GPS parameters
733