Table of Contents
Advertisement
6. Connect the fiber optic cable to the port on the transceiver, as shown
in Figure 89. The connector should snap into the port.
Figure 89. Attaching a Fiber Optic Cable to an SFP Transceiver in the AT-
7. Repeat this procedure to install additional SFP transceivers.
After installing and cabling the SFP transceivers, do one of the following:
To install and cable additional transceivers, go to the appropriate
section in this chapter for instructions.
After cabling all the ports in the chassis, go to Chapter 7,
"Powering On the Chassis" on page 153.
Download from Www.Somanuals.com. All Manuals Search And Download.
SBx31GS24 Line Card
SwitchBlade x3112 Installation Guide
135
Advertisement
Table of Contents
