Programming Console Of Integrated Indicator; Algorithm Of Integrated Indicator Programming - Belarus 3522.5 Operator's Manual

- upon sequential pushing the button "Value" a change of a numeric value of the set
programmable parameter takes place;
- the programming mode is exited automatically when the buttons "Parameter" and
"Value" are not pushed within seven seconds.
When the programming mode is exited the last parameter values chosen with the but-
ton "Value" are stored.
To choose a nonfixed value of a parameter of the Integrated Indicator programming the
following shall be done:
- with the button "Parameter" (figure 3.23.3)choose a parameter, the value of which is to
be set;
- push the button "Mode" twice, after that on multi-functional indicator 17 (figure 2.17.1)
the least significant digit of a numeric value will start flashing;
- the flashing digit of a parameter is changed by pushing the button "Value";
- transit to the more significant digit is carried out by pushing the button "Parameter";
- the mode of programming a nonfixed value of any parameter is exited by a double
pressing the button "Mode";
- after the given mode is exited (input of nonfixed parameter value) digits of the set pa-
rameter value stop flashing;
A newly entered value is set last in the list of parameter values permitted for program-
ming.
Upon single pressing the button "Mode" in the programming mode entering an arbitrary
value of a parameter is not possible.
If the buttons "Mode", "Parameter", "Value" are not pressed within seven seconds in the
mode of entering a nonfixed value, the Integrated Indicator transits into the main mode of mul-
tifunctional indicator storing the set parameter values.
It is allowed to enter one nonfixed value within the following range:
for "Z"parameter: from 23 to 69;
for "I"parameter: from 1.000 to 4.000;
for "R"parameter: from 400 to 1000;
for "KV2"parameter: from 0.346 to 0.600;
for "ZV"parameter: from 12 to 99;
for "V"parameter: from 0 to 1000.
194
https://tractormanualz.com/
3522.5-0000010 РЭ