Table of Contents
Advertisement
Virtual Private Networks (VPN)
1. Log into the IX10 WebUI as a user with Admin access.
2. On the menu, select Status > IPsec.
The IPsec page appears.
3. To view configuration details about an IPsec tunnel, click the (configuration) icon in the
upper right of the tunnel's status pane.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured IPsec tunnels, type the following at the prompt:
> show ipsec all
Name
------
ipsec1
vpn1
>
3. To display details about a specific tunnel:
> show ipsec tunnel ipsec1
Tunnel
Enable
Status
Hostname
Zone
Mode
Type
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Debug an IPsec configuration
If you experience issues with an IPsec tunnel not being successfully negotiated with the remote end of
the tunnel, you can enable IPsec debug messages to be written to the system log. See
and event logs
for more information about viewing the system log.
Web
IX10 User Guide
Enable
Status
Hostname
------
-------
---------------
true
up
192.168.2.1
false
pending
192.168.3.1
: ipsec1
: true
: pending
: 192.168.2.1
: ipsec
: tunnel
: esp
IPsec
View system
293
Advertisement
Table of Contents
