Table of Contents
Advertisement
Hotspot
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change the default maximum download speed:
(config)> network hotspot hotspot bandwidth_max_down value
(config)>
where value is an integer between 1 and 100000 and represents the maximum download speed
in Kbps.
4. Change the default maximum upload speed:
(config)> network hotspot hotspot bandwidth_max_up value
(config)>
where value is an integer between 1 and 100000 and represents the maximum upload speed in
Kbps.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Add an Ethernet port to the default hotspot
Required configuration items
Enable default hotspot configuration. See
n
instructions.
Ethernet port to be added to the hotspot.
n
To add an Ethernet port to the default hotspot:
WebUI
Digi Connect EZ 4/4i User Guide
Enable hotspot using the default configuration
Hotspot configuration
for
274
Advertisement
Table of Contents
