Table of Contents
Advertisement
15-6
EMD Module (EcoX-Bus)
Inappropriate Use
Areas of Use and Application
The equipment described in this documentation is intended for use while
connected to a digital drive controller with a corresponding interface.
Using this equipment, additional digital inputs/outputs are added to a drive
controller.
To use this equipment, additional sensors and actors need to be
connected.
Note:
The input/output modules may only be used with the
accessories and parts specified in this document. If a
component has not been specifically named, then it may not
be either mounted or connected. The same applies to cables
and lines.
Operation is only permitted in the specified configurations and
combinations of components using the software and firmware
as specified in the relevant function descriptions.
The input/output modules may only be operated under the specified
conditions of mounting and installation, in the specified area of use and
according to the specified environmental requirements (temperature, type
of protection, humidity, EMV, etc.).
Using the input/output modules outside of the above-referenced areas of
application or under operating conditions other than described in the
document and the technical data specified is defined as "inappropriate
use."
Input/Output modules may not be used if:
•
... they are subject to operating conditions that do not meet the above
specified ambient conditions. This includes, for example, operation
under water, in the case of extreme temperature fluctuations or
extremely high maximum temperatures.
•
Rexroth has not specifically released them for that intended purpose.
Please note the specifications outlined in the general Safety
Guidelines!
ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Advertisement
Table of Contents
