F- 0227 Control Signal Bit 2 Fault; F- 0228 Control Signal Bit 3 Fault; F- 0229 Control Signal Bit 4 Fault; F- 0230 Offset Dimension Too Small - Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS Functional Description

12-56
Diagnostic Message Descriptions

F- 0227 Control signal bit 2 fault

F- 0228 Control signal bit 3 fault

F- 0229 Control signal bit 4 fault

F- 0230 Offset dimension too small

F- 0300 Invalid I/O number in command instruction

F- 0301 I/O status illegal

The function was activated in Parameters AA14 and AA16, to compare
PLS positions with a particular state of an input signal. The state of the
input signal from Parameter AA16 did not correspond to the PLS position.
Check input signal and PLSs.
The function was activated in Parameters AA14 and AA17, to compare
PLS positions with a particular state of an input signal. The state of the
input signal from Parameter AA17 did not correspond to the PLS position.
Check input signal and PLSs.
The function was activated in Parameters AA14 and AA18, to compare
PLS positions with a particular state of an input signal. The state of the
input signal from Parameter AA18 did not correspond to the PLS position.
Check input signal and PLSs.
The offset dimension in the 'LAR' command is too small. It must be longer
than twice the distance:
•
2
A106 / (2*A109)
•
resp. indicated in the 'CLG' command
Cause:
An NC command for setting one (or more) output bit(s) uses an output bit
that has already been occupied by a parameter or the Logic Task. Double
assignment of output bits in the NC program, Logic Task or parameters is
not possible.
Remedy:
Use a different available output bit.
The bit status indicated in the 'AEA,' 'AKN' or 'BCE' command is not '0' or
'1.'
Cause:
•
Wrong variable content.
•
Data error.
ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P