Table of Contents
Advertisement
ECODRIVE03-FL*-04VRS
15.8 Replacement of a Unit
Replacement of the Electronic
Replacement of the Base Module
Replacement of the Drive
Controller
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
CAUTION
Following is a short list of items that must be considered when a unit is
replaced.
First, please note that the replacement of a unit in a drive control
system – consisting of a drive controller and an input/output module –
always also affects the unit that is not replaced.
The electronic module is plugged into the base module. The
Module
Removal/Installation has already been described. The wiring of the
input/output module is not affected by replacing the electronic module.
For (re-)startup instructions for the electronic module, please see the
corresponding section.
For (re-)startup of the base module, the same description is valid as for
the electronic module.
A physical connection to the drive controller exists via the EcoX interface.
It is also necessary to set the parameters for the drive controller, so it can
communicate with the input/output module. Setting the parameters is not
necessary if the programming module is transferred to the replacement
unit.
Damage by live parts!
⇒ Turn off the power to the input/output module before
installing or removing it, so it is not damaged.
EMD Module (EcoX-Bus)
15-23
Advertisement
Table of Contents
