E- 0106 Jog, Position < Limit; E- 0107 Jog, Position > Limit; E- 0108 Ids01 - Timeout; E- 0109 Load Default Values - Bosch Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS Functional Description

12-64
Diagnostic Message Descriptions
E- 0106 Jog, Position < Limit
E- 0107 Jog, Position > Limit
E- 0108 IDS01 – Timeout

E- 0109 Load default values

E- 0110 Jog, no power

Reverse jogging is not possible. The 'negative position limit value' has
been reached or exceeded.
Remedy:
Move the axis with the signal 'jog forward' into the motion range.
Forward jogging is not possible. The 'positive position limit value' has
been reached or exceeded.
Remedy:
Move the axis with the signal 'jog reverse' into the motion range.
The Interface to the IDS-01 decade switch is interrupted.
Cause:
•
IDS-01 Power Supply.
•
Cable Connection.
•
Parameter settings for the Interface.
Default values are loaded. Triggered by S1 probe with the Address 97-99
or via an interface command.
In Manual Mode, one of the inputs 'Jog forward' or 'Jog reverse' was
applied when the power was off.
ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P