Table of Contents
Advertisement
12-44
Diagnostic Message Descriptions
D800 Command Measuring Wheel Mode
D801 Measuring Wheel Mode not possible
Definition:
The command is active.
The position loop is closed using Encoders 1 and 2.
Control loop monitoring is deactivated.
Cause:
Measuring Wheel Mode was activated.
See also "Measuring Wheel Mode" in the Chapter entitled Functions.
"d8" Display
Cause:
Measuring Wheel Encoder not connected.
ECODRIVE03-FL*-04VRS
DOK-ECODR3-FL*-04VRS**-FK01-EN-P
Advertisement
Table of Contents
Need help?
Do you have a question about the Rexroth OptiFeed-FS EcoDrive 03 FLP04VRS and is the answer not in the manual?
Questions and answers