Gear Bracket Assembly; Lift Shaft Rear Tray Cable Pulley - Xerox WorkCentre 5222 Service Manual

3
Remove the screws (3)
2
Remove the gears
(2)
1
Remove the oval
shaped Plate
Figure 1 Gear Bracket Assembly
5. At the rear of the HCF Tray, begin to free up movement of the Tray Cable Pulley.
2)
a. Remove the E-Ring on the Lift Shaft.
b. Slide the Bushing to the left on the Lift Shaft.
NOTE: You will not be able to release the cable ends from underneath the Tray
Cable Pulley until you perform the next step, which puts slack in the cable enabling
the Lift Shaft to be disengaged from its bracket, and the Tray Cable Pulley moved
farther to the left releasing the cable ends.
Repairs and Adjustments
REP 7.3.4
4
Remove the Gear
Bracket Assembly
2
Slide the Bushing away
from the frame
1
Remove the E-ring
Figure 2 Lift Shaft rear Tray Cable Pulley
6. Preparing to remove the Rear Tray Cable.
a. Remove (2) E-Rings, (2) Wire Guides, and (2) Pulleys. See also
(Figure
February, 2008
4-40
Tray Cable Pulley
(Figure 3)
WorkCentre 5225, 5230
Figure 6 (a).
Launch Version