Xerox WorkCentre 5222 Service Manual page 987

7. Remove the Bottom Plate. (Figure
(1)Release Clamps (5) and remove the wires.
(2)Disconnect Connectors (8).
(3)Remove wires from Hooks (4).
(4)Remove Screws (4).
(5)Remove Bottom Plate.
Figure 2 Removing the Bottom Plate (j0fa42267)
8. Remove the Stacker Tray. (Figure 3)
(1)Release wires from Clamps (5).
(2)Disconnect the Connector.
(3)Remove Screws (5).
(4)Remove the Stacker Tray.
Figure 3 Removing the Stacker Tray (af422107)
Repairs and Adjustments
REP 22.9.4
2) 9. Remove the screws securing the Eject/Set Clamp Motor Assembly.
(1)Release Clamps (2) and remove the wires.
(2)Remove Screws (2).
(3)Remove Tapping Screws (2).
Figure 4 Removing Screws (j0fa42281)
February, 2008
4-210
(Figure 4)
Launch Version
WorkCentre 5225, 5230