Aligning The Eject Cover (J0St41681); Removing The Eject Cover (J0St41682); Rep 16.2.5 Eject Cover - Xerox WorkCentre 5222 Service Manual

REP 16.2.5 Eject Cover

Parts List on PL 23.10
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the Eject Cover. (Figure 1)
a. Unlatch the Eject Cover, and move it to the left.
b. Remove the Retaining Screw (1).
c. Push the Latch through the hole in the Cover.
d. Remove the Cover by moving it to the left.
Retaining
Screw
Eject
Cover
Latch
Figure 1 Removing the Eject Cover (j0st41682)
Repairs and Adjustments
REP 16.2.5
WARNING
Replacement
1. Align the Eject Cover with the Pins (2) on both sides, and slide it to the right.
NOTE: The left side of the Cover is now captured by the Pins and cannot be lifted up.
Pin (2)
Figure 2 Aligning the Eject Cover (j0st41681)
February, 2008
4-136
(Figure 2)
Eject Cover
Launch Version
WorkCentre 5225, 5230