Rep 22.9.5 Rear Tamper Home Sensor - Xerox WorkCentre 5222 Service Manual

10. Remove the Eject/Set Clamp Motor Assembly.
(1)Remove Belts (2) from Pulleys.
(2)Remove Eject/Set Clamp Motor Assembly.
Figure 5 Removing the Eject/Set Clamp Motor Assembly (j0fa42282)
Replacement
1. Reverse the removal procedure for replacement.
Launch Version
WorkCentre 5225, 5230
(Figure 5)
February, 2008

REP 22.9.5 Rear Tamper Home Sensor

Parts List on PL 22.10
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the A-Finisher from the machine.
2. Remove the Inner Front Cover.
3. Remove the Rear Cover. (PL
4. Turn over the A-Finisher.
5. Remove the Bottom Cover. (PL
6. Remove the Connector Bracket.
(1)Release Clamps (3) and remove the wires.
(2)Disconnect Connectors (5).
(3)Remove Screws (2).
(4)Remove Connector Bracket.
Figure 1 Removing the Connector Bracket (j0fa42266)
4-211
WARNING
(REP 22.1)
(PL 22.1)
22.1)
22.2)
(Figure 1)
Repairs and Adjustments
REP 22.9.4, REP 22.9.5