Releasing The Docking Latch (J0St41731.Jpg); Rep 16.2.2 Front Cover Assembly - Xerox WorkCentre 5222 Service Manual

2
Docking latch
will move also
1
Using a large
common screw-
driver, move the
docking latch
release toward
the front of the
Finisher
Figure 2 Releasing the docking latch (j0st41731.jpg)
Replacement
1. Align the Printer Docking Bracket with the cut outs in the Finisher Docking Bracket.
2. Mate the Printer and the Finisher until it latches.
3. Check that the Finisher is firmly latched to the Printer.
4. Perform the remainder of the replacement procedure in reverse order of removal.
Repairs and Adjustments
REP 16.2.1, REP 16.2.2

REP 16.2.2 Front Cover Assembly

Parts List on PL 23.6
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Undock the Finisher. (REP
Do not drop the Booklet Maker Thumb screw into the Finisher.
2. Remove the Booklet Maker and set aside.
3. Open the Finisher upper Front Door.
4. Remove the screws (5).
5. Remove the Front Cover Assembly.
Replacement
1. To install, carry out the removal steps in reverse order.
February, 2008
4-134
WARNING
16.2.1)
CAUTION
(REP 16.3.2)
WorkCentre 5225, 5230
Launch Version