Installing The Set Clamp Shaft Into Position (J0St41725); Preparing To Install The Holder Springs (3) (J0St41729) - Xerox WorkCentre 5222 Service Manual

Figure 11 Installing the Set Clamp Shaft into position (j0st41725)
5. Slide the 3 Set Clamp Holders with Springs into the correct location on the Shaft.
12)
Launch Version
WorkCentre 5225, 5230
1
Insert
the front
end of
the shaft
into the
front
frame
2
Insert
the rear
end of
the Shaft
into the
rear
frame
(Figure
Figure 12 Preparing to install the Holder Springs (3) (j0st41729)
6. Install the Bushing, Spring and Gear onto the rear end of the Set Clamp Shaft.
February, 2008
4-149
Holders and Springs in cor-
rect location on the Shaft
Repairs and Adjustments
(Figure 13)
REP 16.2.13