Removing The Wire Guide (J0St41698); Removing The Stapler Move Motor (J0St41696) - Xerox WorkCentre 5222 Service Manual

3. Remove the Wire Guide. (Figure 2)
a. Pull out the Cable Clamps (3), and remove the wires from the Wire Guide.
b. Remove the Screws (2).
c. Remove the Wire Guide.
Cable Clamps
Figure 2 Removing the Wire Guide (j0st41698)
Repairs and Adjustments
REP 16.2.11
Screws
Wire Guide
February, 2008
4. Remove the Stapler Move Motor.
a. Remove the wires from the Cable Clamp.
b. Disconnect the Connector.
c. Remove the Screws (2).
d. Remove the Stapler Move Motor.
Connector
Stapler Move Motor
Figure 3 Removing the Stapler Move Motor (j0st41696)
Replacement
1. Reverse the removal procedure for replacement.
4-142
(Figure 3)
Cable Clamp
WorkCentre 5225, 5230
Screws
Launch Version