Preparing To Remove The Set Clamp Shaft (J0St41723); Preparing To Remove The Set Clamp Shaft (J0St41724) - Xerox WorkCentre 5222 Service Manual

3
Disconnect the Spring
from the Gear
Figure 7 Preparing to remove the Set Clamp Shaft (j0st41723)
16. Slide the Gear, Spring and the Bushing away from the frame.
Launch Version
WorkCentre 5225, 5230
2 1
Slide the Gear away Remove the E-ring
from the frame
(Figure 8)
2
Slide the Gear, Spring and Bushing toward
the end of the Shaft
Figure 8 Preparing to remove the Set Clamp Shaft (j0st41724)
17. Slide the Set Clamp Shaft to the front to clear the rear frame then slide the Shaft to the
rear and remove it from the Finisher.
February, 2008
4-147
1
Unlock and remove
the Flag
(Figure 9)
Repairs and Adjustments
REP 16.2.13