Removing The Bracket Assembly (J0Fa42272); Removing The Kl-Clips (J0Fa42273); Removing The Eject Shaft (J0Fa42274); Rep 22.9.6 Eject Shaft Assembly - Xerox WorkCentre 5222 Service Manual

REP 22.9.6 Eject Shaft Assembly

Parts List on PL 22.9
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the A-Finisher from the machine.
2. Remove the Compile Assembly. (REP
3. Remove the Bracket Assembly. (Figure
(1)Release Clamps (2) and remove the wires.
(2)Remove Screws (2).
(3)Remove Bracket Assembly.
Figure 1 Removing the Bracket Assembly (j0fa42272)
Launch Version
WorkCentre 5225, 5230
WARNING
(REP 22.1)
22.9.1)
1)
4. Remove the KL-Clips from the Eject Shaft.
(1)Remove KL-Clips (2).
Figure 2 Removing the KL-Clips (j0fa42273)
5. Remove the Eject Shaft from the Front/Rear Tamper Motor Assembly.
(1)Move Bearings (2) in the direction of the arrows.
(2)Remove Eject Shaft in the direction of the arrow.
(3)Remove the Belts from the Pulleys.
Figure 3 Removing the Eject Shaft (j0fa42274)
February, 2008
4-213
(Figure 2)
(Figure 3)
Repairs and Adjustments
REP 22.9.6